Basic Electrical Engineering Test

Q.  For induction motors,

a. Should be essentially a constant speed motor
b. Its speed reduces to some extent with increase in load
c. Does not need to be synchronized
d. All of these


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  To move electrons from valence band to conduction band, the energy applied to the insulator is
Category: Electrical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Valence electrons of silicon and germanium are
Category: Electrical Engineering Questions,   Published by: T-Code Scripts
MCQs:  At low temperature, the semi conductor behaves as a
Category: Electrical Engineering Questions,   Published by: T-Code Scripts
MCQs:  If an external electric field is applied across the intrinsic semiconductor, then the
Category: Electrical Engineering Questions,   Published by: T-Code Scripts
MCQs:  According, to Kirchoff’s voltage law
Category: Electrical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Electrical work is
Category: Electrical Engineering Questions,   Published by: T-Code Scripts
MCQs:  If a current of 5A flows through a resistor of 12 ohm then the power developed and the energy dissipated in 2 minutes are
Category: Electrical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The unit of electrical energy is / are
Category: Electrical Engineering Questions,   Published by: T-Code Scripts
MCQs:  If a number of resistors are connected in parallel, then the reciprocal of total resistance is equal to
Category: Electrical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Permeability of a material is
Category: Electrical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The amount of flux density set up in the core is dependent upon
Category: Electrical Engineering Questions,   Published by: T-Code Scripts
MCQs:  When a solenoid attracts an iron bar,
Category: Electrical Engineering Questions,   Published by: T-Code Scripts
MCQs:  If two conductors carrying currents in opposite direction are placed parallel to each other then the magnetic field set up by the conductors
Category: Electrical Engineering Questions,   Published by: T-Code Scripts
MCQs:  According to the End Rule, the current directions when looked from one end of the coil if that end is South Pole and if the end is North Pole are
Category: Electrical Engineering Questions,   Published by: T-Code Scripts
MCQs:  When the flux crosses the air gap, it bulges outward at the ends of the air gap and the flux density in the air gap is reduced. This is known as
Category: Electrical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The induced emf sets up the direction of current in such a way that the magnetic field produced by it
Category: Electrical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which among the following sentences is correct?
Category: Electrical Engineering Questions,   Published by: T-Code Scripts
MCQs:  If the magnetic field is stationary and the conductor is in motion then the emf induced is called
Category: Electrical Engineering Questions,   Published by: T-Code Scripts
MCQs:  “ Total electric flux through any closed surface is equal to the charge enclosed by that surface ”. This is
Category: Electrical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Gauss’s law is applicable for
Category: Electrical Engineering Questions,   Published by: T-Code Scripts