Refrigeration & Air Conditioning Mcqs

Q.  For better COP of refrigerator, the pressure range corresponding to temperature in evaporator and condenser must be____________________?

a. small
b. high
c. equal
d. anything
e. under some conditions small and under some conditions high


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  On the pressure-enthalpy diagram, condensation and desuperheating is represented by a horizontal line because the process ________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The leaks in a refrigeration system using Freon are detected by____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Moisture in freon refrigeration system causes________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Super heating in a refrigeration cycle __________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  For obtaining high COP, the pressure range of compressor should be_______________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The C.O.P of a refrigeration cycle with increase in evaporator temperature, keeping condenser temperature constant, will______________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Most of the domestic refrigerators work on the following refrigeration system _________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Reducing suction pressure in refrigeration cycle_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The refrigeration effect in a dry evaporator compared to flooded evaporator in a similar plant is_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following refrigerants has lowest freezing point_______________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The change in evaporator temperature in a refrigeration cycle, as compared to change in condenser temperature, influences the value of C.O.P_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The COP of a vapor compression plant in comparison to vapor absorption plant is ________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The evolution of heat of solution takes place in ammonia absorption plant when _____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The C.O.P. of a refrigeration cycle with lowering of condenser temperature, keeping the evaporator temperature constant, will__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Cooling water is required for following equipment in ammonia absorption plant__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The general rule for rating refrigeration systems (excepting for C02 system) is to approximate following h.p. per ton of refrigeration__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Vertical lines on pressure-enthalpy chart show constant_______________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The coefficient of performance is the ratio of the refrigerant effect to the_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Under-cooling in a refrigeration cycle_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The suction pipe diameter of refrigerating unit compressor in comparison to delivery side is_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts