Design of Machine Elements

Q.  For applications involving high stresses in one direction only the following type of thread would be best suited______________________?

a. ISO metric thread
b. acme thread
c. square thread
d. buttress thread
e. British Association thread


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Taper on the cotter and slot is provided_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Silver-based solder is used for__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In order to permit the thermal expansion/contraction of tubing, it should be______________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The strap end of a connecting rod of steam engine is joined by_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The shear plane in case of bolts should_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  When a nut is tightened by plaping a washer below it, the bolt will be subjected to following type of loads___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The edges of the plates for cylindrical vessels are usually bevelled to an angle of 80° for_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following pipe joints would be suitable for pipes carrying steam_____________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The shearing stresses in the inner face as compared to outer face of the wire in a heavy close coiled spring is_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Spring stiffness is__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  When a close coiled helical spring is compressed, its wire is subjected to________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Belt slip may occur due to________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  If two springs are in parallel then their overall stiffness will be_______________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Antifriction bearings are__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The usual clearance provided in hydrodynamic bearing per mm of diameter of shaft is___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Oil in journal bearing should be applied at the point where load is________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In oilness bearings________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Three different weights fall from a certain height under vacuum. They will take______________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In standard taper roller bearings, the angle of taper of outer raceway is___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Whether any core is required in wire ropes________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts