MCQs: The allowable tensile stress in structural mild steel plates for steel tank is assumed as________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: Which of the following sections should preferably be used at places where torsion occurs ?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: The bracing between two columns of a steel tank will be designed to resist_________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: Maximum pitch of rivets, used in steel stacks, is limited to_______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: If the floor is supported at or near the bottom but top chords of a bridge are not braced, then the bridge is called________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: The effect of racking forces is considered in the design of_________________?
i) lateral braces
ii) chord members
The correct answer is
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: The sway bracing is designed to transfer____________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: The bracing provided in the plane of end posts is called__________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: The least dimension in case of a circular column of diameter D is taken as_______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: In case of timber structures, the simple bending formula M = fz may be applied for________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: The mechanism method and the statical method give__________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: Shape factor is a property which depends________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: The mechanism method of plastic analysis satisfies___________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: The ratio of plastic section modulus to elastic section modulus__________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: Which of the following conditions is to be satisfied both in elastic and plastic analysis ?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: As per IS:800, in the plastic design, which of the following pairs are correctly matched? Working Loads Load factor________________?
(i) Dead load 1.7
(ii) Dead Load + imposed load 1.7
(iii) Dead load + load due to wind or 1.3 seismic forces
(iv) Dead load + imposed load + load 1.7
due to wind or seismic forces Of these statements
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: In case of plastic design, the calculated maximum shear capacity of a beam as per IS:800 shall be________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: The moment of inertia of the pair of vertical stiffeners about the center line of the web should not be less than__________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: For a compression member with double angle section, which of the following section will give larger value of minimum radius of gyration?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: A steel beam supporting loads from the floor slab as well as from wall is termed as________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|