Mechanical Operations Mcqs for Chemical

Q.  Flow of filtrate through the cake in a plate and frame filter press is best described by the ______________ equation?

a. Kozeny-Carman
b. Hagen-Poiseuille’s
c. Fanning’s
d. Kremser


ANSWER: See Answer
 
No explanation is available for this question!
TasDia Network - Mcqs | Signature | Lyrics
MCQs:  Toothed roll crushers achieve size reduction by___________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Agglomeration of individual particles into clusters (flocs) is called flocculation. To prevent flocculation, the most commonly used dispersing agents are________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Capacity (in tons/hr) of jaw/gyratory crusher is equal to (where, L = length of the receiving opening, cm S = greater width of the discharge opening, cm) ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Mixing mechanism employed in a pan mixer is by ________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Length/diameter ratio of a ball mill is __________________ ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Shell and leaf filter as compared to plate and frame filter _____________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A propeller agitator_______________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which one is a filter aid ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Crushing efficiency is the ratio of the ______________________ ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Screen capacity is expressed in terms of____________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  General mechanism of size reduction in intermediate and fine grinder is by __________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  In a size reduction crushing operation, feed size is 100 to 300 mm. while the product size is 10 to 50 mm. This is a case of the _____________ crushing?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Percentage of drum submerged in the slurry in case of rotary drum filter is ________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Where the density difference of the two liquid phase to be separated is very small (as in milk cream separator), the most suitable separator is a____________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The optimum moisture content in solids to be crushed/ground ranges from _______________ percent?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Critical Speed (Nc) of a ball mill is given by (where R1 and R2 are radii of ball mill and the ball respectively) ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Ribbon blenders are exclusively meant for __________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which of the following size reduction equipments employs mainly attrition for ultrafine grinding ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  During agitation of liquids, the_________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The important dimensional group involved in the power requirement calculation in mixing operation is the _____________ number?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts