IC Engines Mcqs


Q.  Exhaust pipes of engines are covered with insulating marterial in order to_________________?

a. keep the exhaust pipes warm
b. reduce formation of condenstae
c. reduce heat transfer to the engine room
d. increase engine efficiency
e. conserve heat


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  In petrol engine using a fixed octane rating fuel and fixed compression ratio, super charging will_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  In open combustion chamber in diesel engines____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Which of the following engines can work on very lean mixture__________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Hot air standard diesel cycle efficiency with increase in value of C„_______________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  For low load operation, more suitable (economical) engine is_______________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  For the same size and weight, a two stroke engine as compared to four stroke engine will generate power_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  If diesel is fed by mistake in the oil tank of a petrol engien, then engine will________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  An engine has a normal speed of 960 r.p.m. and no load speed of 1000 r.p.m. The speed droop of governor will be about___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  In isochronous governing, speed droop is_______________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Method of governing used in diesel engine is__________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Method of governing used in petrol engine is________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The termal efficiency of a petrol engine at design load is around_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  As the number of cylinders in multi-cylinder engine increases, the power to weight ratio_______________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  All the four operations in two stroke engine are performed in following number of revolutions of crank shaft______________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  In the case of petrol engine at maximum output, the percentage of CO in exhaust gases is ____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  In a diesel engine, injection pressure developed by injector is of the order of______________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  In precombustion chamber in diesel engine________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The thermal efficiency of a semi-diesel cycle having fixed compression ratio and fixed quantity of heat, with increase in pressure ratio will_______________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  In the case of compression ignition engine, the %age of CO in exhaust gases is________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  A two stroke engine is usually identified by__________________?
Category: Mechanical Engineering Questions,   Published by: teswesm