Design of Machine Elements

Q.  Endurance limit or fatigue limit is the maximum stress that a member can withstand for an infinite number of load applications without failure when subjected to________________?

a. dynamic loading
b. static loading
c. combined static and dynamic loading
d. completely reversed loading
e. all of the above


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  The fatigue limit of a material____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Yield point in fatigue loading as compared to static loading is__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The building up of worn and uridersized parts, subjected to repeated loads by electroplating is_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which process will increase the fatigue duration of parts ?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In nitrated parts, the origins of the fatigue cracks will occur at__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Cold working________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Residual stress in materials_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The ratio of endurance limit in shear to the endurance limit in flexure is__________________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Resistance to fatigue of a material is measured by________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  For steel, the ultimate strength in shear as compared to ultimate strength in tension is ___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  At low temperatures (say 75°C) the notched-bar impact value of steel____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The crest diameter of a screw thread is same as _____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Maximum principal stress theory is applicable for_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A stud________________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A tap bolt_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The included angle in unified of American National threads is___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Cap screws are___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The deflection of a cantilever beam under load W is 8. If its width is halved, then the deflection under load W will be________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Set screws are_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  An alien bolt is___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts