Power Electronics Mcqs

Q.  During the commutation period in 3 phase converter, overlap time is____________?

a. Dependent on the load current
b. Dependent on the voltage
c. Dependent on both the load current and load voltage behind the short circuit current
d. Independent on both the load current and load voltage


ANSWER: See Answer
 
No explanation is available for this question!
TasDia Network - Mcqs | Signature | Lyrics
MCQs:  If all the SCR’s of 3 phase PAC is replaced by diodes, they would be triggered_____________?
Category: Electrical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The ability of an electronic system to function properly in its intended electromagnetic environment and should not be a source of pollution to that electromagnetic environment is known as____________?
Category: Electrical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The opposite of susceptibility is___________?
Category: Electrical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The output current in PWM DC – DC converters is equal to___________?
Category: Electrical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A step – down choppers can be used in___________?
Category: Electrical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In a lossless inverter, the average power absorbed in one period by the load must be__________?
Category: Electrical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The ac voltage controller can be used for ___________?
Category: Electrical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In a full bridge VSI, in order to avoid the short circuit across the DC bus and the undefined AC output voltage condition, the modulating technique should ensure that___________?
Category: Electrical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The phase angle of gate signal in TRIAC can be shifted by using_____________?
Category: Electrical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In the SPWM, the modulating signal is___________?
Category: Electrical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A TRIAC can be turned on with______________?
Category: Electrical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The transfer function of PWM is generally developed in______________?
Category: Electrical Engineering Questions,   Published by: T-Code Scripts
MCQs:  DIAC and TRIAC both are semiconductors devices and conduct in____________________?
Category: Electrical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The Graetz bridge makes excellent use of ______________?
Category: Electrical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In constant frequency PWM, at perturbation the amplitude of the sinusoidal component is a___________?
Category: Electrical Engineering Questions,   Published by: T-Code Scripts
MCQs:  If the firing angle becomes negative, then the rectifier begins to work as_______________?
Category: Electrical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In a 3 phase half wave rectifier, when firing angle is less than 90 degree, then the average dc output voltage becomes__________________?
Category: Electrical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Transformer utilization factor is a measure of the merit of a rectifier circuit. It is the ratio of_______________?
Category: Electrical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A carrier based PWM technique in CSI is composed of____________?
Category: Electrical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In a square – wave operation of 3 phase CSIs, the power values are on for___________?
Category: Electrical Engineering Questions,   Published by: T-Code Scripts