Chemical Engineering Basics Mcqs

Q.  Dies for wire drawing are generally made of__________________?

a. Mild steel
b. Stainless steel
c. Carbides
d. High carbon steel


ANSWER: See Answer
 
No explanation is available for this question!
TasDia Network - Mcqs | Signature | Lyrics
MCQs:  Elimination of brittleness resulting from welding of saw blades is done by __________________ of the welded portion ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  In a neutral solution__________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  At 100% relative humidity, the dew point temperature of moist air is_________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  ____________________ of hard alloy and tool steel is done to make it easily machinable ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  In the Bayer’s process, bauxite is digested under pressure using ___________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Closeness of packing is maximum in case of ____________________ crystal lattice?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Brittleness induced due to the presence of sulphur in steel can be reduced by adding______________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  For a thermodynamic system undergoing a process, which of the following pairs best expresses the relationship similar to that expressed by the pressure volume plot ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The hardenability of steel decreases with__________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Diamagnetic materials___________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  What is the value of included angle of a triangular notch for maximum discharge ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which of the following is a boiler accessory i.e., not a boiler mounting ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The most important requirement for aluminium industry is the availability of cheap _______________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Steel containing low percentage of nickel, chromium & tungsten are termed as the _____________ steel ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Materials having resistivity ranging from 1 to 100 ohm. cm is termed as___________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Plasma is_____________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Heat flow across a hollow sphere of inner radius ‘r1’ and outer radius ‘r2’ is directly proportional to__________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Tempering of a material does not improve its____________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  In connection with corrosion of metals, passivation is the process that__________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  On oscilloscope screen for dynamic measurement, lissajous diagram is normally used to determine the ______________ of the input signal?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts