Highway Engineering Mcqs


Q.  “Dead Slow” is a______________?

a. regulatory sign
b. warning sign
c. informatory sign
d. none of the above


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  The ductility value of bitumen for suitability in road construction should not be less than____________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Which of the following represents hardest grade of bitumen ?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Bitumen of grade 80/100 means______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Softening point of bitumen to be used for read construction at a place where maximum temperature is 40° C should be______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The group index for a soil, whose liquid limit is 40 percent, plasticity index is 10 percent and percentage passing 75 micron IS sieve is 35, is______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Group index method of design of flexible pavement is_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Flexible pavement distribute the wheel load_____________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The method of design of flexible pavement as recommended by IRC is____________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Penetration test on bitumen is used for determining its_____________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The recommended grade of tar for grouting purpose is_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The maximum limit of water absorption for aggregate suitable for road construction is____________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  RC-2, MC-2 and SC-2 correspond to_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  For rapid curing cutbacks, the oil used is______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Bottom most layer of pavement is known as_____________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The number of repetitions, which the pavement thickness designed for a given wheel load should be able to support during the life of pavement is______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Tyre pressure influences the______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Select the correct statement_____________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Rigidity factor for a tyre pressure greater than 7 kg/cm2 is_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Tie bars in cement concrete pavements are at______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The function of an expansion joint in rigid pavements is to______________?
Category: Civil Engineering Mcqs,   Published by: teswesm