Refrigeration & Air Conditioning Mcqs

Q.  Critical temperature is’ the temperature above which _____________________?

a. a gas will never liquefy
b. a gas will immediately liquefy
c. water will evaporate
d. water will never evaporate
e. none of the above


ANSWER: See Answer
 
No explanation is available for this question!
TasDia Network - Mcqs | Signature | Lyrics
MCQs:  A refrigeration cycle operates between condenser temperature of + 27°C and evaporator temperature of- 23°C. The Cannot coefficient of performance of cycle will be_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In vapor compression refrigeration system, refrigerant occurs as liquid between_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Efficiency of a Carnot engine is given as 80%. If the- cycle direction be reversed, what will be the value of COP of reversed Carnot cycle_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Aqua ammonia is used as refrigerant in the following type of refrigeration system_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  If a heat pump cycle operates between the condenser temperature of +27°C and evaporator temperature of – 23°C, then the Carnot COP will be_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In a refrigeration cycle, the flow of refrigerant is controlled by___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The lower horizontal line of the refrigeration cycle plotted on pressure-enthalpy-diagram represents_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Freon group of refrigerants are___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In vapour compression cycle using NH3 as refrigerant, initial charge is filled at_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  On the pressure-enthalpy diagram, condensation and desuperheating is represented by a horizontal line because the process ________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The leaks in a refrigeration system using Freon are detected by____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Moisture in freon refrigeration system causes________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Super heating in a refrigeration cycle __________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  For obtaining high COP, the pressure range of compressor should be_______________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The C.O.P of a refrigeration cycle with increase in evaporator temperature, keeping condenser temperature constant, will______________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Most of the domestic refrigerators work on the following refrigeration system _________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Reducing suction pressure in refrigeration cycle_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The refrigeration effect in a dry evaporator compared to flooded evaporator in a similar plant is_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following refrigerants has lowest freezing point_______________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The change in evaporator temperature in a refrigeration cycle, as compared to change in condenser temperature, influences the value of C.O.P_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts