Stoichiometry Mcqs for Chemical


Q.  Concentration of a solution expressed in terms of _______________ is independent of temperature?

a. Molarity
b. Normality
c. Molality
d. None of these


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  How many phases are present at eutectic point ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Measurement of the amount of dry gas collected over water from volume of moist gas is based on the___________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Saturated molal absolute humidity of the vapor-gas mixture depends upon the______________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Pick out the wrong statement about the recycle stream in a process ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Osmotic pressure of the solution can be increased by_________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Two solutions A1 and A2 have pH value of 2 and 6 respectively. It implies that the solution_____________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  1 bar is almost equal to __________________________ atmosphere?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  In physical adsorption, as compared to chemisorption, the________________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  If 1.5 moles of oxygen combines with aluminium to form Al2O3, then the weight of aluminium (atomic weight = 27) used in this reaction is __________ gm?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The number of H+ in 1 c.c solution of pH 13 is__________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Pick out the wrong statement?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Pick out the wrong statement?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Pick out the correct conversion?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Pick out the wrong statement?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Addition of zircon to silica refractory brick improves its_________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Refractory bricks with lower permeability is produced by using _________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Beryllia (which is used in making crucibles for melting uranium & thorium) is superior to alumina in all respects for high temperature (> 1900°C ) use, except______________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Water content in ground refractory material to be shaped into bricks by hand moulding is about _____________ percent?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Maximum alumina content in high alumina refractory can be as high as ____________ percent?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Panel test determines the ______________ of refractories?
Category: Chemical Engineering Mcqs,   Published by: teswesm