Design of Machine Elements


Q.  Coaxing is the procedure of increasing__________________?

a. metal strength by cycling
b. metal hardness by surface treatment
c. metal resistance to corrosion by coating
d. fatigue limit by overstressing the metal by successively increasing loadings
e. none of the above


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Resistance to fatigue of a material is measured by________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  For steel, the ultimate strength in shear as compared to ultimate strength in tension is ___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  At low temperatures (say 75°C) the notched-bar impact value of steel____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The crest diameter of a screw thread is same as _____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Maximum principal stress theory is applicable for_____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  A stud________________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  A tap bolt_____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The included angle in unified of American National threads is___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Cap screws are___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The deflection of a cantilever beam under load W is 8. If its width is halved, then the deflection under load W will be________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Set screws are_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  An alien bolt is___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Ball bearing type screws are found in following application_____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The function of a washer is to___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  For applications involving high stresses in one direction only the following type of thread would be best suited______________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Shear stress theory is applicable for____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The following type of nut is used with alien bolt____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  If d is the diameter of bolt hole then for a flanged pipe joint to be leak proof, the circumferential pitch of the bolts should be_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  A bolt___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The endurance limit in shear of carbon steel can be obtained by multiplying the endurance limit in flexure by a factor of____________?
Category: Mechanical Engineering Questions,   Published by: teswesm