Refrigeration & Air Conditioning Mcqs


Q.  Choose the correct statement?

a. A refrigerant should have low latent heat
b. If operating temperature of system is low, then refrigerant with low boiling point should be used
c. Precooling and subcooling bf refrigerant are same
d. Superheat and sensible heat of a. refrigerant are same
e. Refrigerant is inside the lubes in case of a direct-expansion chiller


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  The specific heat of superheated steam in kcal/kg is generally of the order of___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  A wet vapour can be completely specified by__________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  On Mollier chart, free expansion, or throttling process from high pressure to atmosphere is represented by_______________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The dry saturated steam at very low pressure, (5-10 kg/cm2) when throttled to atmosphere will become________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The dry saturated steam at very high pressure (150-200 kg/cm2) when throttled to atmosphere will become_______________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  In a throttling process_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Latent heat of dry steam at atmospneric pressure is equal to____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  At critical point, i.e. p=225.65 kg/cm2, the latent enthalpy of vaporisation is______________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  In an experiment to determine dryness fraction of steam, the mass of water separated was 1.2 kg in 15 mts and the mass of steam passed out in same time was 4.8 kg. Dryness fraction is__________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Heating wet steam at constant temperature is heating it at constant_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The state of vapour under saturation condition is described by_______________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Water boils when its vapour pressure ___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Equivalent evaporation of water is the evaporation “for a feed water supply at 100°C__________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The increase in pressure _________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Hygrometery deals with the_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Alkaline pyrogallate is used in Orsat’s apparatus for absorption of _________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Efficiency of rankine cycle can be increased by_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Efficiency of a thermal cycle increases by ________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Which of the following gases has the highest calorific value ________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  For burning 1 kg of carbon to CO as per chemically correct combusiton, amount of air required is___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm