Highway Engineering Mcqs


Q.  Centre line markings are used_____________?

a. to designate traffic lanes
b. in roadways meant for two way traffic
c. to indicate that overtaking is not permitted
d. to designate proper lateral placement of vehicles before turning to different directions


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  The group index for a soil, whose liquid limit is 40 percent, plasticity index is 10 percent and percentage passing 75 micron IS sieve is 35, is______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Group index method of design of flexible pavement is_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Flexible pavement distribute the wheel load_____________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The method of design of flexible pavement as recommended by IRC is____________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Penetration test on bitumen is used for determining its_____________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The recommended grade of tar for grouting purpose is_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The maximum limit of water absorption for aggregate suitable for road construction is____________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  RC-2, MC-2 and SC-2 correspond to_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  For rapid curing cutbacks, the oil used is______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Bottom most layer of pavement is known as_____________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The number of repetitions, which the pavement thickness designed for a given wheel load should be able to support during the life of pavement is______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Tyre pressure influences the______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Select the correct statement_____________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Rigidity factor for a tyre pressure greater than 7 kg/cm2 is_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Tie bars in cement concrete pavements are at______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The function of an expansion joint in rigid pavements is to______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The maximum spacing of contraction joints in rigid pavements is_____________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The critical combination of stresses for corner region in cement concrete roads is____________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  If the group index value of subgrade is between 5 and 9, then the subgrade is treated as_____________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The maximum thickness of expansion joint in rigid pavements is______________?
Category: Civil Engineering Mcqs,   Published by: teswesm