MCQs: Boiling point of water gets lowered at high altitudes (e.g., hills), because ___________________?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
MCQs: The leaching solvent used in Baeyer’s process for the purification of bauxite is___________________?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
MCQs: With increase in annealing temperature, the following defect density decreases?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
MCQs: A gas which is collected over water becomes moistened due to water vapor, exerts its own partial pressure at the gas temperature, which is termed as its_______________?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
MCQs: Addition of _______________ to steel does not help in improving its machinability ?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
MCQs: Brass parts with high residual tensile stress at the surface are susceptible to season cracking (i.e. spontaneous cracking occuring on exposure to atmospheric corrosion), if its zinc percentage is more than ?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
MCQs: Alloying elements present in Haynes stellite, which has superior performance than high speed steel, are____________________?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
MCQs: _______________ test can be termed as the semi-destructive test?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
MCQs: Dowtherm is a____________________?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
MCQs: Boiler tube size is specified by its thickness and _____________________ diameter ?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
MCQs: The rolling process cannot be used to produce______________________?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
MCQs: In “Imperial Smelting Process” for extraction of zinc, zinc vapour thus produced is quenched in the external condenser by the use of the following _______________________?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
MCQs: The most suitable material of construction for a sewer to carry sewage under high pressure is________________________?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
MCQs: Which of the following is not a dielectric material ?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
MCQs: Particle nature of cathode rays is proved due to the fact that they ________________?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
MCQs: Which of the following is prone to cup and cone fracture ?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
MCQs: Minimum safe distance between two liquid fuel storage tanks is equal to (where, H = height of the tank) ?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
MCQs: Austempering process results in the formation of ________________ structure ?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
MCQs: Good design of the casing of a centrifugal pump aims at minimising the __________________________?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
MCQs: The ratio of mass of a neutron to that of an electron is about 1839. What is the ratio of the mass of a proton to that of an electron ?
Category: Chemical Engineering Mcqs, Published by: teswesm
|