Design of Steel Structures Mcqs

Q.  By providing sufficient edge distance, which of the following failures of riveted joint can be avoided ?

a. tension failure of the plate
b. shear failure of the rivet
c. shear failure of the plate
d. crushing failure of the rivet


ANSWER: See Answer
 
No explanation is available for this question!
TasDia Network - Mcqs | Signature | Lyrics
MCQs:  The slenderness ratio of lacing bars should not exceed________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Shear buckling of web in a plate girder is prevented by using________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Minimum thickness of web in a plate girder, when the plate is accessible and also exposed to weather, is______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  As per IS : 800, for compression flange, the outstand of flange plates should not exceed________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Bearing stiffener in a plate girder is used to__________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Gantry girders are designed to resist_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Rivets connecting flange angles to cover plates in a plate girder are subjected to_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The range of economical spacing of trusses varies from________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Normally, the angle of roof truss with asbestos sheets should not be less than_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Generally the purlins are placed at the panel points so as to avoid__________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The relation between intensity of wind pressure p and velocity of wind V is taken as_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The internal pressure coefficient on walls for buildings with large permeability is taken as_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The risk coefficient k, depends on__________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Area of openings for buildings of large permeability is more than_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The number of seismic zones in which the country has been divided are_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The allowable tensile stress in structural mild steel plates for steel tank is assumed as________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which of the following sections should preferably be used at places where torsion occurs ?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The bracing between two columns of a steel tank will be designed to resist_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Maximum pitch of rivets, used in steel stacks, is limited to_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  If the floor is supported at or near the bottom but top chords of a bridge are not braced, then the bridge is called________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts