MCQs: Rankine’s theory of failure is applicable for following type of materials___________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: A hot short metal is_________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The permissible stress for carbon steel under static loading is generally taken as__________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The ultimate strength of steel in tension in comparison to shear is in the ratio of__________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The fatigue limit of a material____________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Yield point in fatigue loading as compared to static loading is__________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The building up of worn and uridersized parts, subjected to repeated loads by electroplating is_____________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Which process will increase the fatigue duration of parts ?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: In nitrated parts, the origins of the fatigue cracks will occur at__________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Cold working________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Residual stress in materials_________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The ratio of endurance limit in shear to the endurance limit in flexure is__________________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Resistance to fatigue of a material is measured by________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: For steel, the ultimate strength in shear as compared to ultimate strength in tension is ___________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: At low temperatures (say 75°C) the notched-bar impact value of steel____________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The crest diameter of a screw thread is same as _____________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Maximum principal stress theory is applicable for_____________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: A stud________________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: A tap bolt_____________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The included angle in unified of American National threads is___________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|