MCQs: Caking coals are those which __________________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The ultimate analysis of fuel lists _____________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Tertiary air is the air used to____________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Heating value of fuel used is as on fired basis. If it is reported for dry or moisture free fuel, then latter should be multiplied by the following factor to correct for as fired value ___________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Incomplete combustion can be best judged by__________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Pulverized fuel is used for___________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Evaporative capacity of boiler is expressed as____________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The balanced draft furnace is one using _________________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Maximum energy loss in a boiler occurs due to _______________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: A supercritical boiler is one that operates above the pressure and temperature of following values_____________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The steam temperature with increase in load in case of a boiler fitted with radiation super heater________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The relative heat absorption for successively added equal areas of boiler convection heating surfaces____________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Fire tube boilers are limited to a maximum design working pressure of ____________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: In water wall furnace, the heat is transferred to the water-walls by _________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The feed check valve is used in order to ______________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The basic job of feed water treatment in boilers is to overcome the problem of __________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The size of a boiler drum in pulverised fuel fired boiler,as its size and capacity, (steam pressure and flow ratings) increase __________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: For the same diameter and thickness of tube, a water tube boiler compared to a fire tube boiler has ____________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Film boling occurs at _______________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: During storage, the heating value of coal __________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|