Design of Machine Elements

Q.  Basic hole is one_________________?

a. whose upper deviation is zero
b. whose lower deviation is zero
c. whose lower as well as upper deviations are zero
d. does not exist
e. none of the above


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  A bench vice has following type of threads____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Applications in which stresses are encountered in one direction only uses following type of threads____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  If threads on a bolt are left hand, threads on nut will be_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Elastic nut is a locking device in which__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Turn buckle has____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A tapered key which fits in a keyway in the hub and is flat on the shaft, is known as___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A key capable of tilting in a recess milled out in a shaft is known as______________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Buttress threads are usually found on____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Jam nut is a locking device in which _____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  If the tearing efficiency of a riveted joint is 75%, then the ratio of diameter of rivet to the pitch is equal to___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following is a permanent fastening ?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Rivets are generally specified by_______________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The designation M 33 x 2 of a bolt means___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Atomic number of an element in the periodic table represents the numbers of_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which is not identical for an atom and an isotope_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A nuclear unit becoming critical means_______________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The total energy released in fission of U is__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Boiling water reactor employs__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  One gram of uranium will produce energy equivalent to approximately____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Breeder reactor has a conversion ratio of_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts