Production Technology Mcqs

Q.  Bar charts are suitable for_____________________?

a. minor works
b. major works
c. large projects
d. all of the above
e. none of the above


ANSWER: See Answer
 
No explanation is available for this question!
TasDia Network - Mcqs | Signature | Lyrics
MCQs:  Pick up the incorrect statement from the following?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Pick up the correct statement from the following?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A file removes the metal during___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In a _____________ , both cutting and non-cutting operations are performed at one station of the press in every stroke of the ram?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A neutral flame is obtained by supplying___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The cold working of metals is carried out_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Lancing is the operation of _________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In spot welding, the spacing between two spot weld should not be less than _______________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The shrinkage allowance for cast iron pattern is________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Tandem drawing of wires and tubes is necessary because_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The operation of straightening a curved sheet metal, is known as____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following statement is wrong ?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following cycles uses air as the refrigerant__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The relative coefficient of performance is_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Clapeyron equation is applicable for registration at___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In vapor compression cycle, the condition of refrigerant is very wet vapor________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A refrigerant should have _____________________? Pick up the wrong statement ?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Clapeyron equation is a relation between___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In vapor compression cycle, the condition of refrigerant is high pressure saturated liquid________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The boiling point of ammonia is___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts