MCQs: Stress may be defined as_________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: For permissible shear stress fs, the torque transmitted by a thin tube of mean diameter D and wall thickness t, is________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: A three hinged arch is generally hinged at its supports and__________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: A truss containing j joints and m members, will be a simple truss if_________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: The locus of reaction of a two hinged semicircular arch, is_________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: section modulus of a square section of side B and that of a circular section of The ratio of the diameter D, is___________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: The radius of gyration of a rectangular section (depth D, width B) from a centroidal axis parallel to the width is__________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: a uniform circular bar of diameter d and length , which extends by an The deflection of amount under a tensile pull , when it carries the same load at its midspan, is___________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: The equivalent length of a column of length L having one end fixed and the other end free, is______________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: The equivalent length is of a column of length having both the ends fixed, is_________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: A steel bar 20 mm in diameter simplysupported at its ends over a total span of 40 cm carries a load at its centre. If the maximum stress induced in the bar is limited to N/mm2, the bending strain energy stored in the bar, is___________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: The maximum deflection of a simply supported beam of span L, carrying an isolated load at the centre of the span; flexural rigidity being EI, is______________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: In a shaft, the shear stress is not directly proportional to_________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: Beams composed of more than one material, rigidly connected together so as to behave as one piece, are known as________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: Shear strain energy theory for the failure of a material at elastic limit, is due to_________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: The S.F. diagram of a loaded beam shown in the given figure is that of________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: P = /4L² is the equation of Euler’s crippling load, if__________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: A steel rod of sectional area 250 sq. mm connects two parallel walls 5 m apart. The nuts at the ends were tightened when the rod was heated to 100°C. If steel = 0.000012/C°, Esteel = 0.2 MN/mm2, the tensile force developed at a temperature of 50°C, is_________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: H V are the algebraic sums of the forces resolved horizontally and vertically respectively, M is the algebraic sum of the moments of forces about any point, for the equilibrium of the body acted upon____________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: cross sections of bronze and copper bars of equal lengt b c are their Ab and Ac are the respective stresses due to load P. If Pb and Pc are the loads shared by them, (where Eb and Ec are their modulii)____________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts
