Chemical Engineering Basics Mcqs


Q.  As the fluid flow rate increases, the float of the Rotameter____________________?

a. Rises in the tube
b. Rotates at higher speed
c. Rotates at lower speed
d. Drops down in the tube


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Titanium is added to molten aluminium alloys before casting for the purpose of_____________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Nusselt number is related to Grashoff number (Gr) in turbulent & laminar flow respectively, in respect of free convection over a vertical flat plate as_________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Angular displacement can be measured suitably by a______________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Maximum hardenability of steel depends upon its_______________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Electrical conductivities of semi-conductors are of the order of ______________ ohm/cm ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The difference in one unit of Rockwell hardness number corresponds to a difference in the depth of indentation of ______________ mm ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Heating the Hypo-eutectoid steels to 30°C above the upper critical temperature line, soaking at that temperature and then cooling slowly to the room temperature to form a pearlite & ferrite structure is called_______________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Evaporative cooling process employs a combination of cooling and humidification in which the____________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Heat transfer to the water wall in a high pressure water wall type boiler furnace is mainly by_________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Nitriding of a steel part does not increase its__________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Chromium molybdenum steel cannot be welded using ______________ welding ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Which of the following fastening devices has a head at one end and a nut fitted to the other ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The elastic strain in copper is due to the__________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Minimum temperature upto which water can be theoretically cooled down in the cooling tower by evaporative cooling is equal to the ______________ temperature of air?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Factor of safety in machine design is defined as the ratio of ultimate stress to _____________ stress ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Speisses is a mixture of the following ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The difference between gross & net calorific values of fuel is due to the___________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The starting of a car takes time in winter, because the__________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Pressure required to increase the density of water by about 1% is ____________________ atmosphere?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  If the demand for an item is trebled and the order cost is reduced to one third, then the economic order quantity_________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm