Highway Engineering Mcqs


Q.  As per IRC recommendations, the average level of illumination on important roads carrying fast traffic is______________?

a. 10 lux
b. 15 lux
c. 20 lux
d. 30 lux


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  The method of design of flexible pavement as recommended by IRC is____________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Penetration test on bitumen is used for determining its_____________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The recommended grade of tar for grouting purpose is_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The maximum limit of water absorption for aggregate suitable for road construction is____________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  RC-2, MC-2 and SC-2 correspond to_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  For rapid curing cutbacks, the oil used is______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Bottom most layer of pavement is known as_____________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The number of repetitions, which the pavement thickness designed for a given wheel load should be able to support during the life of pavement is______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Tyre pressure influences the______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Select the correct statement_____________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Rigidity factor for a tyre pressure greater than 7 kg/cm2 is_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Tie bars in cement concrete pavements are at______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The function of an expansion joint in rigid pavements is to______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The maximum spacing of contraction joints in rigid pavements is_____________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The critical combination of stresses for corner region in cement concrete roads is____________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  If the group index value of subgrade is between 5 and 9, then the subgrade is treated as_____________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The maximum thickness of expansion joint in rigid pavements is______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The fundamental factor in the selection of pavement type is_____________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Maximum daily traffic capacity of bituminous pavements is______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The aggregates required for one kilometer length of water bound macadam road per meter width and for 10 mm thickness is________________?
Category: Civil Engineering Mcqs,   Published by: teswesm