MCQs: Shear buckling of web in a plate girder is prevented by using________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: Minimum thickness of web in a plate girder, when the plate is accessible and also exposed to weather, is______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: As per IS : 800, for compression flange, the outstand of flange plates should not exceed________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: Bearing stiffener in a plate girder is used to__________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: Gantry girders are designed to resist_________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: Rivets connecting flange angles to cover plates in a plate girder are subjected to_________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: The range of economical spacing of trusses varies from________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: Normally, the angle of roof truss with asbestos sheets should not be less than_______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: Generally the purlins are placed at the panel points so as to avoid__________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: The relation between intensity of wind pressure p and velocity of wind V is taken as_______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: The internal pressure coefficient on walls for buildings with large permeability is taken as_______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: The risk coefficient k, depends on__________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: Area of openings for buildings of large permeability is more than_________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: The number of seismic zones in which the country has been divided are_________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: The allowable tensile stress in structural mild steel plates for steel tank is assumed as________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: Which of the following sections should preferably be used at places where torsion occurs ?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: The bracing between two columns of a steel tank will be designed to resist_________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: Maximum pitch of rivets, used in steel stacks, is limited to_______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: If the floor is supported at or near the bottom but top chords of a bridge are not braced, then the bridge is called________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: The effect of racking forces is considered in the design of_________________?
i) lateral braces
ii) chord members
The correct answer is
Category: Civil Engineering Mcqs, Published by: teswesm
|