Engineering Economy Mcqs

Q.  As applied to capitalized asset, the distribution of the initial cost by a periodic changes to operation as in depreciation or the reduction of a debt by either periodic or irregular prearranged programs is called ___________________?

a. Annuity
b. Amortization
c. Capital recovery
d. Annuity factor


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  The timber floor not spanning on the masonry wall but properly anchored to the wall gives________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which of the following will give higher ratio of brickwork strength to mortar strength ?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Minimum compressive strength in N/mm2 for H1 type mortar used for masonry is_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  For earthquake resistant masonry buildings, the vertical distance between openings one above the other in a load bearing wall shall not be less than_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  In a cavity wall, both leaves of which are load bearing, the effective thickness is taken as________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The use of relatively weak mortar_______________? Consider the following statements. 1. will accommodate movements due to loads and, cracking if any, and will be distributed as thin hair cracks which are less noticeable or harmful. 2. will result in reduction of stresses due to differential expansion of masonry units. select the correct statements.
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A high lime content in a composite cement-lime mortar results in______________? Consider the following statements. 1. slow hardening. 2. quick setting. 3. weaker mortar. select the correct statements.
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Direct load carrying capacity of a brick masonry wall standing freely as against when it supports RC slab will be___________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Assertion A : Limiting value of slenderness ratio for a column is less than that of a wall. Reason R : A column can buckle around either of the two horizontal axes while a wall can buckle around only one axis. Select your answer according to the codes given below.
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  In the case of panel wall subjected to horizontal loads at right angles to the plane of the wall, with the mortar not leaner than Ml type, tensile stress in bending in the vertical direction may be allowed to the extent of _______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The mortars used for masonry construction are classified based on strength in IS 2250 and IS 1905 according to their designations L1,L2, H1, H2, M, M2. The correct sequence of increasing order of their strengths is?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A 200 mm thick wall made of modular bricks is 5 m long between cross walls and 3.8 m clear height between RCC slabs at top and bottom. The slenderness ratio of the wall is________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The basic stress in masonry units having height to width ratio of 1.5 may be increased by a factor of_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  For strengthening a 50 m long and 5 m high straight compound wall built in brick work, which one of the following would be most suitable?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Assertion A : For identical strength, a composite cement-lime mortar is preferred over cement mortar. Reason R : Composite cement-lime mortar has higher drying shrinkage than cement mortar_____________? Select your answer based on the codes given below Codes?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  For masonry built in 1:1:6 cement-lime-sand mix mortar or equivalent, the horizontal shear stress permissible on the area of a mortar bed joint is_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Consider the following statements regarding provision of chases in masonry_________________? (i) No chase should be permitted in a half brick load-bearing wall, (ii) Vertical chases should not be closer than 2 m in any stretch of a wall, (iii) Chases should be provided near to bearings of beams and lintels. Select the the statements ?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Cement mortars richer than 1 : 3 are not used in masonry because_________________? i) there is no gain in strength of masonry ii) there is high shrinkage iii) they are prone to segregation select the correct statements?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A 200 mm thick brick masonry wall made of modular bricks carries an axial load of 30 kN/m from wall above and an eccentric load of 20 kN/m from RCC floor acting at a distance of 47.5 mm from the centre line of the wall. The resultant eccentricity ratio is A. B. C. D. ?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Consider the following statements regarding bands to be provided for strengthening masonry work in masonry buildings constructed in zone III, IV and V? (i) Lintel band is provided at lintel level on partition walls, (ii) Gable band is provided at top of gable masonry below the purlins, (iii) The bands shall be to full width of the wall and not less than 7.5 cm in depth, (iv) The bands shall be made of reinforced concrete only. the correct statements are?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts