MCQs: For a thermodynamic system undergoing a process, which of the following pairs best expresses the relationship similar to that expressed by the pressure volume plot ?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
MCQs: The hardenability of steel decreases with__________________?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
MCQs: Diamagnetic materials___________________?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
MCQs: What is the value of included angle of a triangular notch for maximum discharge ?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
MCQs: Which of the following is a boiler accessory i.e., not a boiler mounting ?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
MCQs: The most important requirement for aluminium industry is the availability of cheap _______________?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
MCQs: Steel containing low percentage of nickel, chromium & tungsten are termed as the _____________ steel ?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
MCQs: Materials having resistivity ranging from 1 to 100 ohm. cm is termed as___________________?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
MCQs: Plasma is_____________________?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
MCQs: Heat flow across a hollow sphere of inner radius ‘r1’ and outer radius ‘r2’ is directly proportional to__________________?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
MCQs: Tempering of a material does not improve its____________________?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
MCQs: In connection with corrosion of metals, passivation is the process that__________________?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
MCQs: On oscilloscope screen for dynamic measurement, lissajous diagram is normally used to determine the ______________ of the input signal?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
MCQs: Which of the following forces does not act on a fluid at rest ?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
MCQs: Cold cracking in the heat affected zone of a high strength steel weld can take place because of the___________________?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
MCQs: Moist climate is the most favourable factor in the site selection far a_________________?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
MCQs: The most important function of a washer is to provide bearing area and washers are normally specified by their hole diameters. The diameter of washer as compared to the nut is__________________?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
MCQs: Powder metallurgy is used to produce__________________?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
MCQs: Primary designation of steel is based on its__________________?
Category: Chemical Engineering Mcqs, Published by: teswesm
|
MCQs: Wohler test is a destructive test to find out the ___________________ strength of a prepared metal specimen ?
Category: Chemical Engineering Mcqs, Published by: teswesm
|