Process Control & Instrumentation Mcqs for Chemical

Q.  ____________ are analysed using a Polarograph?

a. Isotonic solutions
b. Solids
c. Liquids
d. Gases


ANSWER: See Answer
 
No explanation is available for this question!
TasDia Network - Mcqs | Signature | Lyrics
MCQs:  Typical specifications for design stipulates the gain margin and phase margin to be respectively__________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which of the following is an undesirable dynamic characteristic of an instrument ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Phase lag of the frequency response of a second order system to a sinusoidal forcing function______________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  An ideal PID controller has the transfer function [1 + (1/0.55) + 0.25]. The frequency at which the magnitude ratio of the controller is 1, is________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Specific conductance is defined as the reciprocal of resistance in ohms of 1c.c. of liquid at a specified temperature. Its value for distilled water is about ______________ micro mho/cm3?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Sub-zero temperature (< 0°C) can be measured by a constant volume gas thermometer employing ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which of the following measurements can be made by the measurement of emf ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which thermocouple can be used to measure a temperature of around 1400°C ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The closed loop pole of a stable second order system could be_______________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  In a single tank system, the transfer function of level to inlet flow rate is__________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Humidity of air can be determined by a__________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A negative gain margin expressed in decibels means a/an ____________ system?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The term analogous to voltage in a single tank system is the_______________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Dome temperature of blast furnace stove is most accurately measured by a____________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The pressure sensing element of elastic type pressure gauge is never made in the form of a_________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Minute depression of freezing point of a liquid solvent on addition of a solid solute can be best measured by a________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Bourdon tube is never made of________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  For measuring the temperature of a red hot furnace, which is the most suitable instrument ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  With increase in temperature, the electrical conductivity of the platinum used in the resistance thermometer ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Thermal well made of _____________ gives the fastest speed of response, while measuring temperature by thermocouples?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts