Engineering Mechanics Test Questions

Q.  Angle of friction is the_______________________?

a. angle between normal reaction and the resultant of normal reaction and the limiting friction
b. ratio of limiting friction and normal reaction
c. the ratio of minimum friction force to the friction force acting when the body is just about to move
d. the ratio of minimum friction force to friction force acting when the body is in motion
e. ratio of static and dynamic friction


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Surface tension__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A liquid compressed in cylinder has a volume of 0.04 m3 at 50 kg/cm2 and a volume of 0.039 m3 at 150 kg/cm2. The bulk modulus of elasticity of liquid is___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following meters is not associated with viscosity____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Dimensions of surface tension are___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  If mercury in a barometer is replaced by water, the height of 3.75 cm of mercury will be following cm of water________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Increase in pressure at the outer edge of a drum of radius R due to rotation at corad/sec, full of liquid of density p will be___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Kinematic viscosity is dependent upon__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  If w is the specific weight of liquid and k the depth of any point from the surface, then pressure intensity at that point will be________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The units of kinematic viscosity are____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Kinematic viscosity is equal to_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A one dimensional flow is one which_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A pressure of 25 m of head of water is equal to_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  If 850 kg liquid occupies volume of one cubic meter, men 0.85 represents its__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A bucket of water is hanging from a spring balance. An iron piece is suspended into water without touching sides of bucket from another support. The spring balance reading will_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A liquid would wet the solid, if adhesion forces as compared to cohesion forces are________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The point in the immersed body through which the resultant pressure of the liquid may be taken to act is known as_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The conditions for the stable equilibrium of a floating body are___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The angle of contact in case of a liquid depends upon___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Rain drops are spherical because of__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The capillary rise at 20°C in a clean glass tube of 1 mm bore containing water is approximately____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts