Chemical Engineering Basics Mcqs


Q.  Ammonia leakage in the refrigeration system is detected by_________________?

a. Sulphur stick, which on detection gives white smoke
b. Using chemical reagents
c. Its smell
d. Soap solution


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  The difference between gross & net calorific values of fuel is due to the___________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The starting of a car takes time in winter, because the__________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Pressure required to increase the density of water by about 1% is ____________________ atmosphere?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  If the demand for an item is trebled and the order cost is reduced to one third, then the economic order quantity_________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  A dense structure of grinding wheel is not used for the_____________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Direct conversion of thermal energy to electrical energy is facilitated by the____________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Annealing of white cast iron produces _____________________ iron?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Cemented carbide tools are not suitable for cutting___________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Milk is fat dispersed in water. It is an example of__________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Case hardening of a material is__________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  According to thermodynamic Fahrenheit scale, the fundamental interval between ice point to steam point is__________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Energy of the sun arises mainly from __________________ reactions?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The phenomenon occurring during explosion of a hydrogen bomb is___________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Which of the following has the highest value of refractive index ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Resistance of an electrical conductor is proportional to its (where, l = length and A = crosssectional area of the conductor)________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Thermit welding uses the following energy source ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  An alloy of Fe – 0.4 % C is__________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Out of the following, the ________________ pipe has the least corrosion resistance?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The most economical channel section for the fluid flow is the one for which the discharge is maximum for a given cross-sectional area. Vertical velocity distribution in an open channel for laminar flow can be assumed to be_______________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Lead is poured into the joints between two ___________________ pipes?
Category: Chemical Engineering Mcqs,   Published by: teswesm