MCQs: What is a stock of a product which is held by a trade body or government as a means of regulating the price of that product ?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: The ability to meet debts as they become due is known as __________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: The ability to convert assets to cash quickly is known as ________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: What is the basic accounting equation ?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: The financial health of the company is measured in terms of______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: What is an index of short-term paying ability ?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: The common ratio is the ratio of_______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: What is defined as the current assets minus inventories and prepaid expenses ?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: The effective height of free standing nonload bearing wall and column respectively will be_________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: The thickness of each leaf of a cavity wall shall not be less than_________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: A free standing brick wall 20 cm thick is subjected to a wind pressure of 75kg/m2. The maximum height of wall from stability consideration is___________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: If the eccentricity ratio is more than 1/24, then increase in the permissible stress in the design of wall subjected to eccentric loading as per code is_________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: The mode of failure of a very short masonry member having h/t ratio of less than 4 is by _______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: The timber floor not spanning on the masonry wall but properly anchored to the wall gives________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: Which of the following will give higher ratio of brickwork strength to mortar strength ?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: Minimum compressive strength in N/mm2 for H1 type mortar used for masonry is_______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: For earthquake resistant masonry buildings, the vertical distance between openings one above the other in a load bearing wall shall not be less than_________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: In a cavity wall, both leaves of which are load bearing, the effective thickness is taken as________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: The use of relatively weak mortar_______________?
Consider the following statements.
1. will accommodate movements due to loads and, cracking if any, and will be distributed as thin hair cracks which are less noticeable or harmful.
2. will result in reduction of stresses due to differential expansion of masonry units.
select the correct statements.
Category: Civil Engineering Mcqs, Published by: teswesm
|
MCQs: A high lime content in a composite cement-lime mortar results in______________?
Consider the following statements.
1. slow hardening.
2. quick setting.
3. weaker mortar.
select the correct statements.
Category: Civil Engineering Mcqs, Published by: teswesm
|