Structural Design Specifications Mcqs


Q.  All reinforcement should be free from_________________?

a. paints
b. loose rust
c. loose mill scales
d. All the above


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  The ratio of volume of voids to the total volume of soil mass is called______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  If the degree of saturation of a partially saturated soil is 60%, then air content of the soil is______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  If the sand in-situ is in its densest state, then the relative density of sand is_____________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  A pycnometer is used to determine_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  In hydrometer analysis for a soil mass______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  For proper field control, which of the following methods is best suited for quick determination of water content of a soil mass ?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  A soil has a bulk density of 22 kN/m3 and water content 10 %. The dry density of soil is_______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Stoke’s law is valid only if the size of particle is________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Which of the following is a measure of particle size range ?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Uniformity coefficient of a soil is__________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The hydrometer method of sedimentation analysis differs from the pipette analysis mainly in_____________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  According to Atterberg, the soil is said to be of medium plasticity if the plasticity index PI is____________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  If the plasticity index of a soil mass is zero, the soil is______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  When the plastic limit of a soil is greater than the liquid limit, then the plasticity index is reported as_____________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The admixture of coarser particles like sand or silt to clay causes______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  The water content of soil, which represents the boundary between plastic state and liquid state, is known as_________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  At liquid limit, all soils possess________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Toughness index is defined as the ratio of____________________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  If the natural water content of soil mass lies between its liquid limit and plastic limit, the soil mass is said to be in______________?
Category: Civil Engineering Mcqs,   Published by: teswesm
MCQs:  Which of the following soils has more plasticity index ?
Category: Civil Engineering Mcqs,   Published by: teswesm