Design of Steel Structures Mcqs

Q.  According to IS Specifications, the maximum pitch of rivets in compression is_____________________?

a. lesser of 200 mm and 12 t
b. lesser of 200 mm and 161
c. lesser of 300 mm and 32 t
d. lesser of 3 00 mm and 24 t


ANSWER: See Answer
 
where t is thickness of thinnest outside plate or angle
TasDia Network - Mcqs | Signature | Lyrics
MCQs:  Generally the purlins are placed at the panel points so as to avoid__________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The relation between intensity of wind pressure p and velocity of wind V is taken as_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The internal pressure coefficient on walls for buildings with large permeability is taken as_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The risk coefficient k, depends on__________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Area of openings for buildings of large permeability is more than_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The number of seismic zones in which the country has been divided are_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The allowable tensile stress in structural mild steel plates for steel tank is assumed as________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which of the following sections should preferably be used at places where torsion occurs ?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The bracing between two columns of a steel tank will be designed to resist_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Maximum pitch of rivets, used in steel stacks, is limited to_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  If the floor is supported at or near the bottom but top chords of a bridge are not braced, then the bridge is called________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The effect of racking forces is considered in the design of_________________? i) lateral braces ii) chord members The correct answer is
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The sway bracing is designed to transfer____________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The bracing provided in the plane of end posts is called__________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The least dimension in case of a circular column of diameter D is taken as_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  In case of timber structures, the simple bending formula M = fz may be applied for________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The mechanism method and the statical method give__________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Shape factor is a property which depends________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The mechanism method of plastic analysis satisfies___________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The ratio of plastic section modulus to elastic section modulus__________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts