|
MCQs: The diameter of ties in a column should be_______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: The minimum diameter of longitudinal bars in a column is________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: For the design of retaining walls, the minimum factor of safety against overturning is taken as_____________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: The load carrying capacity of a helically reinforced column as compared to that of a tied column is about________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: Due to circumferential action of the spiral in a spirally reinforced column________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: Which of the following R.C. retaining walls is suitable for heights beyond 6m ?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: The temperature reinforcement in the vertical slab of a T-shaped R.C. retaining wall is______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: For a slab supported on its four edges with corners held down and loaded uniformly, the Marcus correction factor to the moments obtained by Grashoff Rankine’s theory_______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: Modulus of elasticity of steel as per IS : 456-1978 shall be taken as______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: If the depth of neutral axis for a singly reinforced rectangular section is represented by kd in working stress design, then the value of k for balanced section_______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: If nominal shear stress tv exceeds the design shear strength of concrete xc, the nominal shear reinforcement as per IS : 456-1978 shall be provided for carrying a shear stress equal to__________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: For a reinforced concrete section, the shape of shear stress diagram is_______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: The main reinforcement in the heel of a T-shaped R.C. retaining wall is provided on______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: In counterfort retaining walls, the main reinforcement in the stem at support is_______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: In a counterfort retaining wall, the main reinforcement in the stem at mid span is provided on_______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: A T-shaped retaining wall mainly conssits of_________________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: To minimise the effect of differential settlement, the area of a footing should be designed for______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: In a pile of length /, the points of suspension from ends for lifting it are located at______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: While designing the pile as a column, the end conditions are nearly_______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
|
MCQs: The critical section for finding maximum bending moment for footing under masonry wall is located_______________?
Category: Civil Engineering Mcqs, Published by: teswesm
|
