Design of Machine Elements


Q.  A stud________________________?

a. has a head on one end and a nut fitted to the other
b. has head at one end and other end fits into a tapped hole in the other part to be joined
c. has both the ends threaded
d. has pointed threads
e. requires locking nuts


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  The pitch of threads on a Jock nut in comparison to pitch of nut is_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  In order to obtain bolt of uniform strength____________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  A key made from a cylindrical disc having segmental cross-section, is known as______________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Fibrous fracture occurs in_____________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Eye bolts are used for_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  If d is the normal diameter of a bolt in mm, then the initial tension in kg in a bolt used for making a fluid tight joint as for steam engine cover joint is calculated by the relation_______________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Taper usually provided on cotter is_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The draw of cotter need not exceed_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The valve rod in a steam engine is connected to an eccentric rod by_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Taper on the cotter and slot is provided_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Silver-based solder is used for__________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  In order to permit the thermal expansion/contraction of tubing, it should be______________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The strap end of a connecting rod of steam engine is joined by_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The shear plane in case of bolts should_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  When a nut is tightened by plaping a washer below it, the bolt will be subjected to following type of loads___________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The edges of the plates for cylindrical vessels are usually bevelled to an angle of 80° for_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Which of the following pipe joints would be suitable for pipes carrying steam_____________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  The shearing stresses in the inner face as compared to outer face of the wire in a heavy close coiled spring is_________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  Spring stiffness is__________________?
Category: Mechanical Engineering Questions,   Published by: teswesm
MCQs:  When a close coiled helical spring is compressed, its wire is subjected to________________?
Category: Mechanical Engineering Questions,   Published by: teswesm