MCQs: Resilience of a material is considered when it is subjected to_________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: When it is indicated that a member is elastic, it means that when force is applied, it will________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The internal reaction in bottom 80 cm length will be________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The ratio of direct stress to volumetric strain in case of a body subjected to three mutually perpendicular stresses of equal intensity, is equal to___________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The elasticity of various materials is controlled by its___________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The stress developed in a material at breaking point in extension is called_________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The stress necessary to initiate yielding is_________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: If a material expands freely due to heating it will develop ____________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The change in the unit volume of a material under tension with increase in its Poisson’s ratio will ________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: For which material the Poisson’s ratio is more than unity_________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The property of a material which allows it to be drawn into a smaller section is called________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The materials which exhibit the same elastic properties in all directions are called______________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The total elongation produced in a bar of uniform section hanging vertically downwards due to its own weight is equal to that produced by a weight________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The value of Poisson’s ratio for steel is between_________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Which of the following materials is most elastic_________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: In a tensile test on mild steel specimen, the breaking stress as compared to ultimate tensile stress is_________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Which of the following has no unit __________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: During a tensile test on a specimen of 1 cm cross-section, maximum load observed was 8 tonnes and area of cross-section at neck was 0.5 cm2. Ultimate tensile strength of specimen is___________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The intensity of stress which causes unit strain is called_______________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The Young’s modulus of a wire is defined as the stress which will increase the length of wire compared to its original length________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|