Design of Machine Elements

Q.  A self locking screw has________________>

a. fine threads
b. coarse threads
c. coefficient of friction > tangent of load angle
d. hole for inserting split pin
e. two nuts for locking


ANSWER: See Answer
 
No explanation is available for this question!
TasDia Network - Mcqs | Signature | Lyrics
MCQs:  Which of the following pipe joints would be suitable for pipes carrying steam_____________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The shearing stresses in the inner face as compared to outer face of the wire in a heavy close coiled spring is_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Spring stiffness is__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  When a close coiled helical spring is compressed, its wire is subjected to________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Belt slip may occur due to________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  If two springs are in parallel then their overall stiffness will be_______________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Antifriction bearings are__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The usual clearance provided in hydrodynamic bearing per mm of diameter of shaft is___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Oil in journal bearing should be applied at the point where load is________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In oilness bearings________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Three different weights fall from a certain height under vacuum. They will take______________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In standard taper roller bearings, the angle of taper of outer raceway is___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Whether any core is required in wire ropes________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Basic shaft is one__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In composite or reverse laid ropes___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  I.S. specifies following total number of grades of tolerances__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Allen bolts are___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The connecting rod bolts are tightened up so that tightening stress _________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  If an application calls for stresses on screw threads in one direction only, then the following type of thread would be best suited ________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The shock absorbing capacity of a bolt can be increased by___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts