MCQs: The value of Poisson’s ratio for steel is between_________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Which of the following materials is most elastic_________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: In a tensile test on mild steel specimen, the breaking stress as compared to ultimate tensile stress is_________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Which of the following has no unit __________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: During a tensile test on a specimen of 1 cm cross-section, maximum load observed was 8 tonnes and area of cross-section at neck was 0.5 cm2. Ultimate tensile strength of specimen is___________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The intensity of stress which causes unit strain is called_______________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The Young’s modulus of a wire is defined as the stress which will increase the length of wire compared to its original length________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Tensile strength of a material is obtained by dividing the maximum load during the test by the_________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: If the radius of wire stretched by a load is doubled, then its Young’s modulus will be_______________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: A thin mild steel wire is loaded by adding loads in equal increments till it breaks. The extensions noted with increasing loads will behave as under_________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The ultimate tensile stress of mild steel compared to ultimate compressive stress is__________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Modulus of rigidity is defined as the ratio of_________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: It equal and opposite forces applied to a body tend to elongate it, the stress so produced is called______________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The unit of Young’s modulus is__________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Hooke’s law holds good up to____________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The stress developed in a material at breaking point in extension is called__________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Which of the following disciplines provides study of the relative motion between the parts of a machine and the forces acting on the parts__________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Which of the following is a lower pair_______________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The example of lower pair is_______________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: A universal joint is an example of_____________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|