MCQs: When a load crosses a through type Pratt truss in the direction left to right, the nature of force in any diagonal member in the left half of the span would_______________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: The deformation of a spring produced by a unit load is called _________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: The width of the analogous column in the method of column analogy is _________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: Muller Breslau’s principle for obtaining influence lines is applicable to___________________?
i) trusses
ii) statically determinate beams and frames
iii) statically indeterminate structures, the material of which is elastic and follows Hooke’s law
iv) any statically indeterminate structure
The correct answer is ?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: Select the correct statement___.?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: A load ‘W is moving from left to right support on a simply supported beam of span T. The maximum bending moment at 0.4 1 from the left support is___________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: In the displacement method of structural analysis, the basic unknowns are__________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: Which of the following methods of structural analysis is a force method ?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: When a uniformly distributed load, shorter than the span of the girder, moves from left to right, then the conditions for maximum bending moment at a section is that___________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: The maximum bending moment due to a train of wheel loads on a simply supported girder_________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: For a symmetrical two hinged parabolic arch, if one of the supports settles horizontally, then the horizontal thrust__________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: Bending moment at any section in a conjugate beam gives in the actual beam_________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: While using three moments equation, a fixed end of a continuous beam is replaced by an additional span of__________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: The degree of static indeterminacy up to which column analogy method can be used is__________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: The carryover factor in a prismatic member whose far end is fixed is___________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: Principle of superposition is applicable when___________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: The principle of virtual work can be applied to elastic system by considering the virtual work of_________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: The number of independent displacement components at each joint of a rigidjointed space frame is_______________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: The degree of static indeterminacy of a rigidjointed space frame is_________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts

MCQs: The number of independent equations to be satisfied for static equilibrium in a space structure is___________________?
Category: Civil Engineering Mcqs, Published by: TCode Scripts
