Chemical Engineering Basics Mcqs


Q.  A reduction in thermal resistance during heat transfer does not occur in the___________________?

a. Convection heat transfer by stirring the fluid and cleaning the heating surface
b. Conduction heat transfer by reduction in the material thickness and increase in the thermal conductivity
c. Radiation heat transfer by increasing the temperature and reducing the emissivity
d. None of these


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  _______________ test can be termed as the semi-destructive test?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Dowtherm is a____________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Boiler tube size is specified by its thickness and _____________________ diameter ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The rolling process cannot be used to produce______________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  In “Imperial Smelting Process” for extraction of zinc, zinc vapour thus produced is quenched in the external condenser by the use of the following _______________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The most suitable material of construction for a sewer to carry sewage under high pressure is________________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Which of the following is not a dielectric material ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Particle nature of cathode rays is proved due to the fact that they ________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Which of the following is prone to cup and cone fracture ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Minimum safe distance between two liquid fuel storage tanks is equal to (where, H = height of the tank) ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Austempering process results in the formation of ________________ structure ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Good design of the casing of a centrifugal pump aims at minimising the __________________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The ratio of mass of a neutron to that of an electron is about 1839. What is the ratio of the mass of a proton to that of an electron ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Matte smelting is used in the extraction of_____________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Carnot cycle is also termed as the constant _________________ cycle in thermodynamics?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Large diameter reinforced cement concrete (RCC) pipes are generally joined by ____________________ joint ?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  A dummy activity is used in PERT network to describe the_____________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  Unit of viscosity in CGS system is_______________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The refractory lining of the bottom in a basic electric arc furnace is made of___________________?
Category: Chemical Engineering Mcqs,   Published by: teswesm
MCQs:  The specific gravity of coal depends mainly on its __________________ content ?
Category: Chemical Engineering Mcqs,   Published by: teswesm