Power Electronics Mcqs


Q.  A GTO can be turned on by applying___________?

a. Positive gate signal
b. Positive drain signal
c. Positive source signal
d. None of these


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Compared to transistor, _________ have lower on state conduction losses and higher power handling capability?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  Materials used in heat sink should have_____________?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  A thyristor can termed as__________?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  Which of the following is used in heat sink_____________?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  How can we protect SCR from thermal conditions _____________?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  Thyristor is nothing but a____________?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  Gate circuit or triggering circuit of a thyristor is
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  After proper turn on of thyristor____________?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  SCR will be turned off when anode current is_______________?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  The capacitance of reversed bised junction J2 in a thyristor is CJ2 = 20 pF and can be assumed to be independant of the off state voltage. The limiting value of the charging current to turn on the thyristor is 16 mA. What is the critical value of dv/dt?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  BCT is used for____________?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  Let of a thyristor Vc1, Vc2, Vc3 are forward break over voltage for gate current Ig1, Ig2, Ig3 respectively. Then________________?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  Which of following devices has highest di/dt and dv/dt capability?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  Which triggering is the most reliable____________?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  Leakage current flows through the thyristor in_________?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  Which of the following is disadvantage of fast recovery diodes?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  When a large surge current of very short duration flows through a thyristor then which one of the following device will operate to protect the thyristor ___________?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  A power semiconductor may undergo damage due to____________?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  CB used for over current protection of thyristor operates when the fault current is__________?
Category: Electrical Engineering Questions,   Published by: teswesm
MCQs:  If the anode current is 800 A, then the amount of current required to turn off the GTO is about____________?
Category: Electrical Engineering Questions,   Published by: teswesm