Heat Transfer Questions

Q.  A grey body is one whose absorptivity _________________?

a. varies with temperature
b. varies with the wave length of incident ray
c. varies with both
d. does not vary with temperature and wave length of the incident ray
e. there is no such criterion


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Centrifugal pump is started with its delivery valve __________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  When a piping system is made up primarily of vertical lift and very little pipe friction, the pump characteristics should be _________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Multistage centrifugal pumps are used to obtain___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In a single casing, multistage pump running at constant speed, the capacity rating is to be slightly lowered. It can be done by_______________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  One horsepower is equal to_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Axial flow pump is started with its delivery valve________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Head developed by a centrifugal pump depends on___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In a centrifugal pump casing, the flow of water leaving the_______________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Reciprocating pumps are no more to be seen in industrial applications (in comparison to centrifugal pumps) because of____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The efficiency of a centrifugal pump is maximum when its blades are__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  When a piping system is made up primarily of friction head and very little of vertical lift, then pump characteristics should be__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  If a pump is handling water and is discharging a certain flow Q at a constant total dynamic head requiring a definite B.H.P., the same pump when handling a liquid of specific gravity 0.75 and viscosity nearly same as of water would discharge_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The optimum value of vane exit angle for a centrifugal pump impeller is_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In centrifugal pumps, maximum efficiency is obtained when the blades are_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In a centrifugal pump, the liquid enters the pump__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Low specific speed of a pump implies it is____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  For small discharge at high pressure, following pump is preferred_____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The horse power required in above case will be___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Motion of a liquid in a volute casing of a centrifugal pump is an example of____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Medium specific speed of a pump implies it is_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts