Strength of Materials Test Questions

Q.  A flywheel on a motor goes from rest to 1000 rpm in 6 sec. The number of revolutions made is nearly equal to_________________?

a. 25
b. 50
c. 100
d. 250
e. 500


ANSWER: See Answer
 
No explanation is available for this question!
TasDia Network - Mcqs | Signature | Lyrics
MCQs:  A beam is loaded as cantilever. If the load at the end is increased, the failure will occur ___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The stress induced in a body due to suddenly applied load compared to when it is applied gradually is________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  A material capable of absorbing large amount of energy before fracture is known as________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The total strain energy stored in a body is termed as__________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Resilience of a material is considered when it is subjected to_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  When it is indicated that a member is elastic, it means that when force is applied, it will________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The internal reaction in bottom 80 cm length will be________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The ratio of direct stress to volumetric strain in case of a body subjected to three mutually perpendicular stresses of equal intensity, is equal to___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The elasticity of various materials is controlled by its___________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The stress developed in a material at breaking point in extension is called_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The stress necessary to initiate yielding is_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  If a material expands freely due to heating it will develop ____________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The change in the unit volume of a material under tension with increase in its Poisson’s ratio will ________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  For which material the Poisson’s ratio is more than unity_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The property of a material which allows it to be drawn into a smaller section is called________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The materials which exhibit the same elastic properties in all directions are called______________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The total elongation produced in a bar of uniform section hanging vertically downwards due to its own weight is equal to that produced by a weight________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  The value of Poisson’s ratio for steel is between_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  Which of the following materials is most elastic_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts
MCQs:  In a tensile test on mild steel specimen, the breaking stress as compared to ultimate tensile stress is_________________?
Category: Mechanical Engineering Questions,   Published by: T-Code Scripts