RCC Structures Design Mcqs

Q.  A continuous beam shall be deemed to be a deep beam if the ratio of effective span to overall depth, is______________?

a. 2.5
b. 2.0
c. Less than 2
d. Less than 2.5


ANSWER: See Answer
 
No explanation is available for this question!
TasDia Network - Mcqs | Signature | Lyrics
MCQs:  If the diameter of longitudinal bars of a square column is 16 mm, the diameter of lateral ties should not be less than____________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  In a combined footing if shear stress does not exceed 5 kg/cm2, the nominal stirrups provided are________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The maximum shear stress (q) in concrete of a reinforced cement concrete beam is_____________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  An R.C.C. column is treated as long if its slenderness ratio is greater than____________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The thickness of base slab of a retaining wall generally provided, is_____________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  If the maximum shear stress at the end of a simply supported R.C.C. beam of 6 m effective span is 10 kg/cm2, the share stirrups are provided for a distance from either end where, is________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Distribution of shear intensity over a rectangular section of a beam, follows_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  In a singly reinforced beam, if the permissible stress in concrete reaches earlier than that in steel, the beam section is called________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Design of R.C.C. simply supported beams carrying U.D.L. is based on the resultant B.M. at________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Design of R.C.C. cantilever beams, is based on the resultant force at______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Distribution reinforcement in a simply supported slab, is provided to distribute_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  If the size of a column is reduced above the floor, the main bars of the columns, are_____________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The minimum number of main steel bars provided in R.C.C________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A short column 20 cm × 20 cm in section is reinforced with 4 bars whose area of cross section is 20 sq. cm. If permissible compressive stresses in concrete and steel are 40 kg/cm2 and 300 kg/cm2, the Safe load on the column, should not exceed_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  If T and R are tread and rise respectively of a stair, then_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  For stairs spanning l metres longitudinally between supports at the bottom and top of a flight carrying a load w per unit horizontal area, the maximum bending moment per metre width, is_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  In a singly reinforced beam, the effective depth is measured from its compression edge to_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Though the effective depth of a T-beam is the distance between the top compression edge to the centre of the tensile reinforcement, for heavy loads, it is taken as__________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  On piles, the drop must be at least_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  In a pre-stressed beam carrying an external load W with a bent tendon is having angle of -stressed load P. The net downward load at the centre is_________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts