Thermodynamics Test Questions

Q.  A closed system is one in which_________________________?

a. mass does not cross boundaries of the system, though energy may do so
b. mass crosses the boundary but not the energy
c. neither mass nor energy crosses the boundaries of the system
d. both energy and mass cross the boundaries of the system
e. thermodynamic reactions take place


ANSWER: See Answer
 
No explanation is available for this question!
MCQs:  Rain drops falling through atmospheric air attain limited terminal velocity, because of ____________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Volume of blast furnace slag is about _______________ times the volume of hot metal (pig iron) of the same weight ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Colour comparator is used to measure the___________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A reduction in thermal resistance during heat transfer does not occur in the___________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Plastics as a material of construction suffer from the drawback of low_________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The thickness of oxide film is y at time t. If K1, K2 and K3 are the temperature dependent constants, the parabolic law of oxidation is given by __________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Biological shield in a nuclear reactor is generally provided to protect against the__________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The most detrimental impurity in high pressure boiler feed water is ___________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Sub zero treatment of steel is done to____________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  In Newton’s law of viscosity, which states that the shear stress is proportional to the _____________ Co-efficient of viscosity is called dynamic or absolute viscosity(where, V = velocity, Vg = velocity gradient) ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which of the following is not categorised as the ore agglomeration process ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Tumbling is the process of improving the ________________ of the materials/parts ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Young’s modulus of a material is the measure of its ___________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which of the following materials has the least scrap value ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Which of the following is used to produce draught in the locomotive boilers ?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Alcohols are not suitable as diesel engine fuel because the cetane number of alcohols is____________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The process of removal of scale formed during hot rolling of steel is termed as_________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Boiling point of water gets lowered at high altitudes (e.g., hills), because ___________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The leaching solvent used in Baeyer’s process for the purification of bauxite is___________________?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  With increase in annealing temperature, the following defect density decreases?
Category: Chemical Engineering Mcqs,   Published by: T-Code Scripts