MCQs: A riveted joint in which every rivet of a row is opposite to other rivet of the outer row, is known as______________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Efficiency of a riveted joint is the ratio of its strength (max. load it can resist without failure) to the strength of the unpunched plate in_________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: In riveted boiler joints, all stresses, shearing, bearing and tensile are based on the_________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The ratio of elongation in a prismatic bar due to its own weight (W) as compared to another similar bar carrying an additional weight (W) will be _________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: A beam is loaded as cantilever. If the load at the end is increased, the failure will occur ___________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The stress induced in a body due to suddenly applied load compared to when it is applied gradually is________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: A material capable of absorbing large amount of energy before fracture is known as________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The total strain energy stored in a body is termed as__________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: Resilience of a material is considered when it is subjected to_________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: When it is indicated that a member is elastic, it means that when force is applied, it will________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The internal reaction in bottom 80 cm length will be________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The ratio of direct stress to volumetric strain in case of a body subjected to three mutually perpendicular stresses of equal intensity, is equal to___________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The elasticity of various materials is controlled by its___________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The stress developed in a material at breaking point in extension is called_________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The stress necessary to initiate yielding is_________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: If a material expands freely due to heating it will develop ____________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The change in the unit volume of a material under tension with increase in its Poisson’s ratio will ________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: For which material the Poisson’s ratio is more than unity_________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The property of a material which allows it to be drawn into a smaller section is called________________?
Category: Mechanical Engineering Questions, Published by: teswesm
|
MCQs: The materials which exhibit the same elastic properties in all directions are called______________?
Category: Mechanical Engineering Questions, Published by: teswesm
|