Estimating & Costing Mcqs

Q.  88 is 1400 kg/cm2 and bond stress is 6 kg/cm2, the If tensile stress of a steel rod of diameter required bond length of the rod is____________________?

a. 30 D
b. 39 D
c. 50 D
d. 59 D


ANSWER: See Answer
 
No explanation is available for this question!
TasDia Network - Mcqs | Signature | Lyrics
MCQs:  Pick up the item whose weight is added to the weight of respective item, is________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The ground surface slopes 1 in 50 along a proposed railway embankment 150 m in length. The height of the embankment at zero chainage is 0.5 m, the width is 11 m and side slopes 2:1. If the falling gradient of the embankment is 1 in 150, the quantity of the earthwork calculated by Prismoidal formula, is____________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  S: 1 and length is______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Pick up the correct statement from the following _______?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Pick up the correct statement from the following ________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Pick up the correct statement from the following _________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The load stress of a section can be reduced by______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The maximum ratio of span to depth of a slab simply supported and spanning in one direction, is______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  the column head support a flat slab, is generally kept The diameter of_____________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The floor slab of a building is supported on reinforced cement floor beams. The ratio of the end and intermediate spans is kept______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  In case the factor of safety against sliding is less than 1.5, a portion of slab is constructed downwards at the end of the heel slab, which is known as___________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Lapped splices in tensile reinforcement are generally not used for bars of size larger than______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  According to I.S. : 456, slabs which span in two directions with corners held down, are assumed to be divided in each direction into middle strips and edge strips such that the width of the middle strip, is______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  If the width of the foundation for two equal columns is restricted, the shape of the footing generally adopted, is__________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Minimum spacing between horizontal parallel reinforcement of the same size should not be less than________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  For a ribbed slab______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  A very comfortable type of stairs is_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  The width of the flange of a L-beam, should be less than______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  An R.C.C. beam of 6 m span is 30 cm wide and has a lever arm of 55 cm. If it carries a U.D.L. of 12 t per m and allowable shear stress is 5 kg/cm2, the beam________________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts
MCQs:  Columns may be made of plain concrete if their unsupported lengths do not exceed their least lateral dimension_______________?
Category: Civil Engineering Mcqs,   Published by: T-Code Scripts